Leg sold separately.

Instructions

• Place the table upside down on a bench with the end even with (or slightly extended over) the edge.  Hang the rod on the table and center.
• Place the J-3 catch brackets over the rod ends and with the lip pf the bracket held up against the table, screw in place. In all instances leave enough space between the edge of the brackets and rod bends to minimize binding.
• With the rod in the same position, turn the table over and place on cleats up against the wall. NOTE: The J-4 brackets must be held in position firmly on the hinge rod when mounting.
• Raise the table to the up position and place the J-1 catch plates over the exposed ends of the rod catch bracket and center.
  
• Bring the catches down as far as feasible (if possible to the top of the table) and fasten the two top holes to the wall.
  
• Since the bottom holes are normally below the top of the table, it is necessary to drop the table to the down position to complete this fastening of the catch plates to the wall.