An ideal primary or secondary heating source in your vintage trailer.
Olympian Wave heaters operate on low pressure LP gas, and can be wall mounted
or used as portables. Equipped with a 100% safety shut-off valve to
prevent accidental non-ignition fuel discharge. The built-in automatic
Piezo electric spark starter will last for 20,000 starts. No electrical
drain or battery connection.
Catalytic heaters produce heat by combining LP gas and oxygen in a
platinum impregnated pad or catalyst. This causes a chemical reaction
(flameless combustion) resulting the release of low intensity infrared
heat. The heater operates below the temperature necessary to support
flame-type combustion and no heat is lost through a vent or flu. Flame
type heaters actually waste up to 45% of all heat produced.
Olympian brand Wave catalytic heaters are 99.98% efficient and are
available in several sizes to fit your needs. Catalytic heaters heat
efficiently, don't take up much space and are extremely safe. None of
the deadly exhaust gases associated with flame heaters are produced
with catalytic units. Wave Heaters are a great value, offering both
safety and clean low-cost heat.
Note:
All combustion processes consume oxygen. Standards
require at least a 1 square inch fresh air opening for
every 1000 BTUs
of propane used by any appliance. Ideally
there would be two vents, one low on an outside wall and
the other high on another outside wall.
This ensures that replacement air (oxygen) is
provided. Opening a window slightly can accomplish this venting.
SPECIFICATIONS
Fuel |
Propane
(LP) gas |
BTU Output: |
1 (Minimum)
3 (Maximum) |
1600
3000 |
Fuel
Consumption on High |
1/4 lb.
per hr. |
Ignition |
Piezo
Spark |
Standard
Gas Connection |
3/8"
SAE flare |
Size:
Height
Width
Depth |
11.75"
10.25"
3.5" |
Weight |
8 lbs |
Area
Heated*
|
Up to 12'
camper/trailer
(130 sq. ft.) |
*
depending on insulation and outside temperature |
Warranty:
- 1 year parts and labor
- Limited 3 year warranty against manufacturer's defects.